D-Link DXS-3600-32S CLI Guide - Page 485

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Default Command Mode Command Default Level Usage Guideline CoS -> queue: 0 -> 2 1 -> 0 2 -> 1 3 -> 3 4 -> 4 5 -> 5 6 -> 6 7 -> 7 Global Configuration Mode. Level: 15 The priority-queue cos-map command use to configure the CoS to queue map table. When a packet is received, the packet will be given an internal CoS. This internal CoS is used to select the transmit queue based on the CoS to queue map table. The CoS queue with higher number owned with higher priority. Example This example shows how to assign the CoS priority 3,5,6 to CoS queue 2. DXS-3600-32S#configure terminal DXS-3600-32S(config)#priority-queue cos-map 2 3 5 6 DXS-3600-32S(config)# 48-13 queue bandwidth This command is used to specify or modify the bandwidth allocated for a CoS. To remove the bandwidth allocated for a CoS, use the no form of this command. queue queue-id bandwidth min max no queue queue-id bandwidth Parameters queue-id min max Specifies the CoS queue to assign bandwidth. Specifies the minimal guaranteed bandwidth in Kbps allocated to a specified COS. Specifies the maximum bandwidth in Kbps for a specified COS. Default Command Mode Command Default Level Usage Guideline No limitation. Interface Configuration Mode. Level: 15 Only physical ports are valid for this command. When the minimal bandwidth is configured, the packet transmitted from the queue can be guaranteed even though the link is congested. When the maximum bandwidth is configured, packets transmitted from the queue cannot exceed the maximum bandwidth even if the bandwidth is available. Note that the configuration of queue bandwidth can only be attached to a physical port but not a port-channel. That is the bandwidth of one CoS cannot be summation across physical ports. 477