D-Link DXS-3600-32S CLI Guide - Page 583

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide 58-2 storm-control action This command is used to enable the specified action. Use the no form of this command to configure this option to the default settings. storm-control action {block | shutdown | drop} no storm-control action Parameters block shutdown drop Specifies the storm-control block the flooding of which storm packets when the value specified for rise threshold is reached, and recover the flooding of which storm packets when the value specified for low threshold is falling. Specifies the storm-control to shutdown the port when the value specified for rise threshold is reached. Specifies the storm-control discard packets that exceed the rise threshold Default Command Mode Command Default Level Usage Guideline The default setting of the action is block storm packets. Interface Configuration Mode. Level: 15 If the port shutdown, you must use the no storm-control action or the no stormcontrol {broadcast | multicast | unicast} commands to recover the port. Example This example shows how to enable the shutdown action on port 1. DXS-3600-32S#configure terminal DXS-3600-32S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)#storm-control action shutdown Success DXS-3600-32S(config-if)# 58-3 storm-control interval This command is used to configure the interval time. Use the no form of the command to default time storm-control interval no storm-control interval Parameters interval Specifies the time interval that the switch checks the storm. The range of 1 to 300 in seconds. Default Command Mode Command Default Level Usage Guideline The default interval time is 5s. Global Configuration Mode. Level: 15 In order to maintain the stability of network state, it is recommended to set the time interval of not less than the default value. 575