D-Link DXS-3600-32S CLI Guide - Page 447

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Protocol Independent Commands 46-1 clear ip route This command is used to remove all or specified static routes from the IP routing table. clear ip route [vrf vrf-name] {* | network [net-mask]} Parameters vrf vrf-name * network net-mask (Optional) Specifies to remove all routes of one VRF. Specifies to remove all static routes. Specifies that the IP address and network address are both accepted. If net-mask is not specified, the longest prefix matched route will be removed. (Optional) Specifies the network mask of the destination network. Default Command Mode Command Default Level Usage Guideline None. Privileged EXEC Mode. Level: 8 Use this command to remove all the static routes or the specified static routes from the IP routing table. If there area multi-paths to one destination, all these static routes will be removed. Users can verify the settings by entering the show ip route static command. Example This example shows how to remove the static route 33.3.3.0/24. DXS-3600-32S#clear ip route 33.3.3.0 255.255.255.0 DXS-3600-32S# Example This example shows how to remove all static routes. DXS-3600-32S#clear ip route * DXS-3600-32S# Example This example shows how to remove the static route 33.3.3.0/24 in VRF VPN-A: DXS-3600-32S#clear ip route vrf VPN-A 33.3.3.0 255.255.255.0 DXS-3600-32S# 46-2 route-preference default This command is used to set the preference of the static default route. Use no form of this command to restore it to the default setting. route-preference [vrf vrf-name] default value no route-preference [vrf vrf-name] default Parameters vrf vrf-name value (Optional) Specifies to set the route preference of VRF routing table. Specifies the preference of the static default route. The value range is 1-999. Default Command Mode The default value of the static default route's preference is 1. Global Configuration Mode. 439