D-Link DXS-3600-32S CLI Guide - Page 541

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to add a set command to modify the metric of routes. DXS-3600-32S#configure terminal DXS-3600-32S(config)#route-map mapmetric permit 10 DXS-3600-32S(config-route-map)#set metric 100 DXS-3600-32S(config-route-map)# 53-17 set metric-type This command is used to add a set command to modify the metric type of routes. Use the no form of this command to delete this set command. set metric-type {type-1 | type-2} no set metric-type Parameters type-1 type-2 Specifies the OSPF external type 1 metric. Specifies the OSPF external type 2 metric. Default Command Mode Command Default Level Usage Guideline None. Route Map Configuration Mode. Level: 8 This command is only applied to the routes redistributed to OSPF. You can verify your settings by entering the show route-map command. Example This example shows how to add a set command to modify the metric type of routes. DXS-3600-32S#configure terminal DXS-3600-32S(config)#route-map mapmetrictype permit 10 DXS-3600-32S(config-route-map)#set metric-type type-1 DXS-3600-32S(config-route-map)# 53-18 set origin This command is used to add a set command to modify the BGP origin code. Use the no form of this command to delete this set command. set origin {igp | egp | incomplete} no set origin Parameters igp egp incomplete Specifies that the origin code of the route will be set to IGP. Specifies that the origin code of the route will be set to EGP. Specifies that the origin code of the route will be set to INCOMPLETE. Default Command Mode Command Default Level None. Route Map Configuration Mode. Level: 8 533