D-Link DXS-3600-32S CLI Guide - Page 536

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows how to add a match command to match source router IP address of routes using standard IP access list. DXS-3600-32S#configure terminal DXS-3600-32S(config)#ip standard access-list LocalServer DXS-3600-32S(config-ip-acl)#permit 172.19.10.1/32 DXS-3600-32S(config-ip-acl)#exit DXS-3600-32S(config)#route-map rmap1 permit 10 DXS-3600-32S(config-route-map)#match ip route-source LocalServer DXS-3600-32S(config-route-map)# 53-9 match metric This command is used to add a match command to match the metric of routes. Use the no form of this command to delete the match command with metric of routes. match metric NUMBER no match metric Parameters NUMBER Specifies the metric of routes. The range is 0 to 4294967294. Default Command Mode Command Default Level Usage Guideline None. Route Map Configuration Mode. Level: 8 You can verify your settings by entering the show route-map command. Example This example shows how to add a match command to match the metric of routes. DXS-3600-32S#configure terminal DXS-3600-32S(config)#route-map rmap1 permit 10 DXS-3600-32S(config-route-map)#match metric 5 DXS-3600-32S(config-route-map)# 53-10 match route-type This command is used to add a match command to match the type of routes. Use the no form of this command to delete the match command with type of routes. match route-type {internal | external | type-1 | type-2} no match route-type Parameters internal external type-1 type-2 Specifies the Intra-area and inter-area routes of Open Shortest Path First (OSPF). Specifies the Autonomous System external route of OSPF, including type-1 and type-2 external routes. Specifies the Type-1 external route of OSPF Specifies the Type-2 external route of OSPF Default Command Mode Command Default Level None. Route Map Configuration Mode. Level: 8 528