D-Link DXS-3600-32S CLI Guide - Page 597

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Example This example shows the result of the show logging command. DXS-3600-32S#show logging Syslog Logging: Enabled Console Logging: Level Informational Buffer Logging: Level Debugging Trap Logging: Level Informational Facility: local1 logging to 10.90.90.4 Logging File Write Delay: On_demand Syslog Source IP Interface Configuration: IP Interface : vlan1 IPv4 Address : 192.168.69.123 DXS-3600-32S# 60-10 show logging count This command is used to show the log statistics. show logging count Parameters Default Command Mode Command Default Level Usage Guideline None. None. EXEC Mode. Level: 15 To use the log packet statistics function, run logging count in the global configuration mode. The show logging count can show the information of a log. Example This example shows the log statistics. DXS-3600-32S#show logging count Total logging Count: 0 DXS-3600-32S# 60-11 logging buffered This command is used to set the memory buffer parameters for logs. The no form of the command disables recording logs in memory buffer. logging buffered [LEVEL] | [write-delay {SECONDS | INFINITE}] no logging buffered Parameters LEVEL SECONDS INFINITE Specifies the severity of log messages, 0 to 7. The name of the severity or the numeral can be used. Specifies the minutes interval to write logs in the flash. Specifies that the logs are not recorded in the flash. Default Command Mode Command Default Level Default level : Debugging(7). Default will log to buffer and disable periodical writing of the logging buffer to FLASH. Global Configuration Mode. Level: 15 589