Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 101

Error Seconds per Time Period Task Command Syntax Command Mode Specify the high threshold value for frame error seconds per time period, or disable the high threshold. Specify the low threshold for frame error seconds per time period. Specify the time period for error second per time period condition. ethernet oam link-monitor frame-seconds threshold high {milliseconds | none} Range: 1-900 Default: None ethernet oam link-monitor frame-seconds threshold low milliseconds Range: 1-900 Default: 1 ethernet oam link-monitor frame-seconds window milliseconds Range: 100-900, in multiples of 100 Default: 1000 milliseconds INTERFACE INTERFACE INTERFACE Execute an Action upon Exceeding the High Threshold When an error exceeds the low threshold, an event notification is sent to the peer. When an error exceeds the high threshold, a pre-defined action is triggered such as disabling the interface. Task Disable an interface when the high threshold is exceeded for any of the monitored error conditions. Command Syntax ethernet oam link-monitor high-threshold action error-disable-interface Default: Enabled Command Mode INTERFACE Remote Failure Indication Remote Failure Indication is the mechanism a system uses to notify its peer of a local critical link event. There are three critical events; each has an associated flag which can be set in the OAMPDU when the event occurs. • Link Fault-A fault occurred in the receive direction of the local peer. • Dying Gasp-An unrecoverable local failure condition occurred. Dying Gasp notification is not supported on S-Series. • Critical Event-An unspecified critical event occurred. Critical Event notification is not supported on S-Series. When a link fault, dying gasp, or critical event occurs, the system sets an associated bit in subsequent OAMPDUs until the error is resolved (polling occurs every 100ms), and you can configure the system to take an additional action.\ 802.3ah | 101