Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 685

Use the following command in CONFIGURATION- ROUTER-OSPF mode to redistribute routes: Command Syntax Command Mode Usage redistribute {bgp | connected | isis | rip | static} [metric metric-value | metric-type type-value] [route-map map-name] [tag tag-value] CONFIG-ROUTER-OSPF-id Specify which routes will be redistributed into OSPF process. Configure the following required and optional parameters: • bgp, connected, isis, rip, or static: enter one of the keyword to redistribute those routes. rip is supported only on E-Series. • metric metric-value range: 0 to 4294967295. • metric-type metric-type: 1 for OSPF external route type 1 or 2 for OSPF external route type 2. • route-map map-name: enter a name of a configured route map. • tag tag-value range: 0 to 4294967295. To view the current OSPF configuration, use the show running-config ospf command in the EXEC mode or the show config command in the ROUTER OSPF mode FTOS(conf-router_ospf)#show config ! router ospf 34 network 10.1.2.32 0.0.0.255 area 2.2.2.2 network 10.1.3.24 0.0.0.255 area 3.3.3.3 distribute-list dilling in FTOS(conf-router_ospf)# Troubleshooting OSPFv2 FTOS has several tools to make troubleshooting easier. Be sure to check the following, as these are typical issues that interrupt an OSPFv2 process. Note that this is not a comprehensive list, just some examples of typical troubleshooting checks. • Has OSPF been enabled globally? • Is the OSPF process active on the interface? • Are adjacencies established correctly? • Are the interfaces configured for Layer 3 correctly? • Is the router in the correct area type? • Have the routes been included in the OSPF database? • Have the OSPF routes been included in the routing table (not just the OSPF database)? Some useful troubleshooting commands are: • show interfaces • show protocols • debug IP OSPF events and/or packets • show neighbors • show virtual links • show routes Open Shortest Path First (OSPFv2 and OSPFv3) | 685