Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 574

www.dell.com | support.dell.com CONFIGURATION versus INTERFACE Configurations All LLDP configuration commands are available in PROTOCOL LLDP mode, which is a sub-mode of CONFIGURATION mode and INTERFACE mode. • Configurations made at CONFIGURATION level are global, that is, they affect all interfaces on the system. • Configurations made at INTERFACE level affect only the specific interface, and they override CONFIGURATION level configurations. R1(conf)#protocol lldp R1(conf-lldp)#? advertise Advertise TLVs disable Disable LLDP protocol globally end Exit from configuration mode exit Exit from LLDP configuration mode hello LLDP hello configuration mode LLDP mode configuration (default = rx and tx) multiplier LLDP multiplier configuration no Negate a command or set its defaults show Show LLDP configuration R1(conf-lldp)#exit R1(conf)#interface gigabitethernet 1/31 R1(conf-if-gi-1/31)#protocol lldp R1(conf-if-gi-1/31-lldp)#? advertise Advertise TLVs disable Disable LLDP protocol on this interface end Exit from configuration mode exit Exit from LLDP configuration mode hello LLDP hello configuration mode LLDP mode configuration (default = rx and tx) multiplier LLDP multiplier configuration no Negate a command or set its defaults show Show LLDP configuration R1(conf-if-gi-1/31-lldp)# Enabling LLDP LLDP is disabled by default. LLDP can be enabled and disabled globally or per interface. If LLDP is enabled globally, all up interfaces send periodic LLDPDUs. To enable LLDP: Step 1 2 Task Enter Protocol LLDP mode. Enable LLDP. Command protocol lldp no disable Command Mode CONFIGURATION or INTERFACE PROTOCOL LLDP Disabling and Undoing LLDP • Disable LLDP globally or for an interface using the command disable. • Undo an LLDP configuration by preceding the relevant command with the keyword no. 574 | Link Layer Discovery Protocol