Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 511

Use the show isis protocol command in EXEC Privilege mode to view which metric types are generated and received. FTOS#show isis protocol IS-IS Router: System Id: EEEE.EEEE.EEEE IS-Type: level-1-2 Manual area address(es): 47.0004.004d.0001 Routing for area address(es): 21.2223.2425.2627.2829.3031.3233 47.0004.004d.0001 Interfaces supported by IS-IS: Vlan 2 GigabitEthernet 4/22 Loopback 0 Redistributing: Distance: 115 Generate narrow metrics: level-1-2 Accept narrow metrics: level-1-2 Generate wide metrics: none Accept wide metrics: none FTOS# When you change from one IS-IS metric style to another, the IS-IS metric value could be affected. For each interface with IS-IS enabled, you can assign a cost or metric that is used in the link state calculation. Use the following command in INTERFACE mode to change the metric or cost of the interface. Command Syntax Command Mode Purpose isis metric default-metric INTERFACE [level-1 | level-2] default-value range: 0 to 63 if the metric-style is narrow, narrow-transition or transition. 0 to 16777215 if the metric style is wide or wide transition. Default: 10. isis ipv6 metric default-metric [level-1 | level-2] INTERFACE Assign a metric for an IPv6 link or interface. • default-metric range: 0 to 63 for narrow and transition metric styles; 0 to 16777215 for wide metric styles. Default is 10. Default level is level-1. Refer to Configure IS-IS metric style and cost for more information on this command. Use the show config command in INTERFACE mode or the show isis interface command in EXEC Privilege mode to view the interface's current metric. Table 26-3. Correct Value Range for the isis metric command Metric Style wide narrow wide transition Correct Value Range 0 to 16777215 0 to 63 0 to 16777215 Intermediate System to Intermediate System | 511