Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 46

www.dell.com | support.dell.com -> 00:00:10: %RPM0-U:CP %RAM-6-ELECTION_ROLE: RPM0 is transitioning to Primary RPM. 00:00:11: %RPM0-P:CP %CHMGR-2-FAN_BAD: Minor alarm: some fans in fan tray 0 are down 00:00:11: %RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 1 present DSA Card Init 00:00:11: %RPM0-P:CP POEMGR-4-POE_POWER_USAGE_ABOVE_THRESHOLD: Inline power used is exceeded 90% of available inline power 00:00:12: %RPM0-P:CP %CHMGR-5-CARDDETECTED: Line card 2 present 00:00:12: %RPM0-P:CP %TSM-6-SFM_SWITCHFAB_STATE: Switch Fabric: UP 00:00:12: %RPM0-P:CP %TSM-6-SFM_FULL_PARTIAL_STATE: SW_FAB_UP_1 SFM in the system 00:00:13: %RPM0-P:CP %IFMGR-5-OSTATE_UP: Changed interface state to up: Ma 0/0 00:01:27: %RPM0-P:CP %CHMGR-5-CHECKIN: Checkin from line card 1 (type E48TB, 48 ports) 00:01:27: %RPM0-P:CP %CHMGR-5-CHECKIN: Checkin from line card 2 (type E48TB, 48 ports) 00:01:28: %RPM0-P:CP %CHMGR-5-LINECARDUP: Line card 1 is up 00:01:28: %RPM0-P:CP %CHMGR-5-LINECARDUP: Line card 2 is up 00:01:36: %RPM0-P:CP %RAM-5-RPM_STATE: RPM0 is in Active State. 00:01:36: %RPM0-P:CP %CHMGR-5-CHAS_READY: Chassis ready 00:01:37: %RPM0-P:CP %SEC-5-LOGIN_SUCCESS: Login successful for user on line console FTOS> Default Configuration A version of FTOS is pre-loaded onto the chassis, however the system is not configured when you power up for the first time (except for the default hostname, which is FTOS). You must configure the system using the CLI. Configure a Host Name The host name appears in the prompt. The default host name is force10. • Host names must start with a letter and end with a letter or digit. • Characters within the string can be letters, digits, and hyphens. To configure a host name: Step Task 1 Create a new host name. Command Syntax hostname name The following example illustrates the hostname command. FTOS(conf)#hostname R1 R1(conf)# Command Mode CONFIGURATION 46 | Getting Started