Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 55

File System Management The Dell Force10 system can use the internal Flash, external Flash, or remote devices to store files. It stores files on the internal Flash by default but can be configured to store files elsewhere. To view file system information: Task View information about each file system. Command Syntax show file-systems Command Mode EXEC Privilege The output of the command show file-systems shows the total capacity, amount of free memory, file structure, media type, read/write privileges for each storage device in use. FTOS#show file-systems Size(b) Free(b) Feature Type Flags 520962048 213778432 dosFs2.0 USERFLASH 127772672 21936128 dosFs2.0 USERFLASH - - - network - - - network - - - network Prefixes rw flash: rw slot0: rw ftp: rw tftp: rw scp: You can change the default file system so that file management commands apply to a particular device or memory. To change the default storage location: Task Change the default directory. Command Syntax cd directory Command Mode EXEC Privilege In the following example, the default storage location is changed to the external Flash of the primary RPM. File management commands then apply to the external Flash rather than the internal Flash. FTOS#cd slot0: FTOS#copy running-config test FTOS#copy run test ! 7419 bytes successfully copied FTOS#dir Directory of slot0: 1 drw- 32768 Jan 01 1980 00:00:00 . 2 drwx 512 Jul 23 2007 00:38:44 .. 3 ---- 0 Jan 01 1970 00:00:00 DCIM 4 -rw- 7419 Jul 23 2007 20:44:40 test 5 ---- 0 Jan 01 1970 00:00:00 BT 6 ---- 0 Jan 01 1970 00:00:00 200702~1VSN 7 ---- 0 Jan 01 1970 00:00:00 G 8 ---- 0 Jan 01 1970 00:00:00 F 9 ---- 0 Jan 01 1970 00:00:00 F slot0: 127772672 bytes total (21927936 bytes free) Getting Started | 55