Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 480

www.dell.com | support.dell.com Hop-by-Hop Options header The Hop-by-Hop options header contains information that is examined by every router along the packet's path. It follows the IPv6 header and is designated by the Next Header value 0 (zero) (Table 25-1, "Next Header field values," in IPv6 Addressing). When a Hop-by-Hop Options header is not included, the router knows that it does not have to process any router specific information and immediately processes the packet to its final destination. When a Hop-by-Hop Options header is present, the router only needs this extension header and does not need to take the time to view further into the packet. The Hop-by-Hop Options header contains: • Next Header (1 byte) This field identifies the type of header following the Hop-by-Hop Options header and uses the same values shown in Table 25-1, "Next Header field values," in IPv6 Addressing. • Header Extension Length (1 byte) This field identifies the length of the Hop-by-Hop Options header in 8-byte units, but does not include the first 8 bytes. Consequently, if the header is less than 8 bytes, the value is 0 (zero). • Options (size varies) This field can contain 1 or more options. The first byte if the field identifies the Option type, and directs the router how to handle the option. 00 Skip and continue processing 01 Discard the packet. 10 Discard the packet and send an ICMP Parameter Problem Code 2 message to the packet's Source IP Address identifying the unknown option type 11 Discard the packet and send an ICMP Parameter Problem, Code 2 message to the packet's Source IP Address only if the Destination IP Address is not a multicast address. The second byte contains the Option Data Length. The third byte specifies whether the information can change en route to the destination. The value is 1 if it can change; the value is 0 if it cannot change. 480 | IPv6 Addressing