Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 608

www.dell.com | support.dell.com GroupAddr 239.0.0.1 SourceAddr 10.11.4.2 RPAddr 192.168.0.1 LearnedFrom Expire UpTime 192.168.0.1 1 00:10:29 [Router 3] R3_E600(conf)#do show ip msdp sa-cache R3_E600(conf)# Display the configured SA filters for a peer using the command show ip msdp peer from EXEC Privilege mode (refer to the example above ). Log Changes in Peership States Task Log peership state changes. Command Syntax ip msdp log-adjacency-changes Command Mode CONFIGURATION Terminate a Peership MSDP uses TCP as its transport protocol. In a peering relationship, the peer with the lower IP address initiates the TCP session, while the peer with the higher IP address listens on port 639. Task Terminate the TCP connection with a peer. Command Syntax ip msdp shutdown Command Mode CONFIGURATION Once the relationship is terminated, the peering state of the terminator is SHUTDOWN, while the peering state of the peer is INACTIVE. [Router 3] R3_E600(conf)#ip msdp shutdown 192.168.0.1 R3_E600(conf)#do show ip msdp peer Peer Addr: 192.168.0.1 Local Addr: 0.0.0.0(0) Connect Source: Lo 0 State: Shutdown Up/Down Time: 00:00:18 Timers: KeepAlive 30 sec, Hold time 75 sec SourceActive packet count (in/out): 0/0 SAs learned from this peer: 0 SA Filtering: Input (S,G) filter: myremotefilter Output (S,G) filter: none [Router 1] R1_E600(conf)#do show ip msdp peer Peer Addr: 192.168.0.3 Local Addr: 0.0.0.0(0) Connect Source: Lo 0 State: Inactive Up/Down Time: 00:00:03 Timers: KeepAlive 30 sec, Hold time 75 sec SourceActive packet count (in/out): 0/0 608 | Multicast Source Discovery Protocol