Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 916

www.dell.com | support.dell.com Polling Intervals The sflow polling-interval command configures the polling interval for an interface in the maximum number of seconds between successive samples of counters to be sent to the collector. This command changes the global default counter polling (20 seconds) interval. You can configure an interface to use a different polling interval. The polling interval can be configured globally (in CONFIGURATION mode) or by interface (in INTERFACE mode) by executing the interval command: . Command Syntax sflow polling-interval interval value Command Mode CONFIGURATION or INTERFACE Usage Change the global default counter polling interval. interval value-in seconds. Range: 15 to 86400 seconds Default: 20 seconds Sampling Rate e Sampling Rate is supported on platform t. The sFlow sampling rate is the number of packets that are skipped before the next sample is taken. sFlow does not have time-based packet sampling. The sflow sample-rate command, when issued in CONFIGURATION mode, changes the default sampling rate. By default, the sampling rate of an interface is set to the same value as the current global default sampling rate.If the value entered is not a correct power of 2, the command generates an error message with the previous and next power-of-2 value. Select one of these two number and re-enter the command. (For more information on values in power-of-2, refer to Sub-sampling.) The sample rate can be configured globally or by interface using the sample rate command: Command Syntax [no] sflow sample-rate sample-rate Command Mode CONFIGURATION or INTERFACE Usage Change the global or interface sampling rate. Rate must be entered in factors of 2 (eg, 4096, 8192). sample-rate range: 256-8388608 for C-Series and S-Series 2-8388608 for E-Series 916 | sFlow