Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 827

Routing Information Sources: Gateway Distance Last Update Distance: (default is 120) FTOS# To configure the interfaces to send or receive different RIP versions from the RIP version configured globally, use either of the following commands in the INTERFACE mode: Command Syntax ip rip receive version [1] [2] ip rip send version [1] [2] Command Mode Purpose INTERFACE INTERFACE Set the RIP version(s) received on that interface. Set the RIP version(s) sent out on that interface. To configure an interface to receive or send both versions of RIP, include 1 and 2 in the command syntax. The example below displays the command syntax for sending both RIPv1 and RIPv2 and receiving only RIPv2. FTOS(conf-if)#ip rip send version 1 2 FTOS(conf-if)#ip rip receive version 2 The show ip protocols command example below confirms that both versions are sent out that interface. This interface no longer sends and receives the same RIP versions as FTOS does globally. FTOS#show ip protocols Routing Protocols is RIP Sending updates every 30 seconds, next due in 11 Invalid after 180 seconds, hold down 180, flushed after 240 Output delay 8 milliseconds between packets Automatic network summarization is in effect Outgoing filter for all interfaces is Incoming filter for all interfaces is Default redistribution metric is 1 Default version control: receive version 2, send version 2 Interface Recv Send FastEthernet 0/0 2 1 2 Routing for Networks: 10.0.0.0 Routing Information Sources: Gateway Distance Last Update Distance: (default is 120) FTOS# Routing Information Protocol | 827