Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 154

www.dell.com | support.dell.com To view the configuration, use the show config command in the ROUTER RIP mode or the show running-config rip command in the EXEC mode. FTOS(conf-router_rip)#show config ! router rip distribute-list prefix juba out network 10.0.0.0 FTOS(conf-router_rip)#router ospf 34 To apply a filter to routes in OSPF, use either of the following commands in the ROUTER OSPF mode: Command Syntax Command Mode router ospf CONFIGURATION distribute-list CONFIG-ROUTER-OSPF prefix-list-name in [interface] distribute-list prefix-list-name out [connected | rip | static] CONFIG-ROUTER-OSPF Purpose Enter OSPF mode Apply a configured prefix list to incoming routes. You can specify an interface. If you enter the name of a non-existent prefix list, all routes are forwarded. Apply a configured prefix list to incoming routes. You can specify which type of routes are affected. If you enter the name of a non-existent prefix list, all routes are forwarded. To view the configuration, use the show config command in the ROUTER OSPF mode or the show running-config ospf command in the EXEC mode. FTOS(conf-router_ospf)#show config ! router ospf 34 network 10.2.1.1 255.255.255.255 area 0.0.0.1 distribute-list prefix awe in FTOS(conf-router_ospf)# ACL Resequencing e Resequencing an ACL or Prefix List is supported on platform ACL Resequencing allows you to re-number the rules and remarks in an access or prefix list. The placement of rules within the list is critical because packets are matched against rules in sequential order. Use Resequencing whenever there is no longer an opportunity to order new rules as desired using current numbering scheme. For example, Table 10-3, "ACL Resequencing Example (Insert New Rules)," in IP Access Control Lists (ACL), Prefix Lists, and Route-maps contains some rules that are numbered in increments of 1. No new rules can be placed between these, so apply resequencing to create numbering space, as shown in Table 10-4, "ACL Resequencing Example (Resequenced)," in IP Access Control Lists (ACL), Prefix Lists, and Route-maps. In the same example, apply resequencing if more than two rules must be placed between rules 7 and 10. 154 | IP Access Control Lists (ACL), Prefix Lists, and Route-maps