Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 823

Configuration Task List for RIP • Enable RIP globally (mandatory) • Configure RIP on interfaces (optional) • Control RIP routing updates (optional) • Set send and receive version (optional) • Generate a default route (optional) • Control route metrics (optional) • Summarize routes (optional) • Control route metrics • Debug RIP For a complete listing of all commands related to RIP, refer to the FTOS Command Reference. Enable RIP globally By default, RIP is not enabled in FTOS. To enable RIP, use the following commands in sequence, starting in the CONFIGURATION mode: Step 1 2 Command Syntax Command Mode Purpose router rip CONFIGURATION Enter ROUTER RIP mode and enable the RIP process on FTOS. network ip-address ROUTER RIP Assign an IP network address as a RIP network to exchange routing information. You can use this command multiple times to exchange RIP information with as many RIP networks as you want. After designating networks with which the system is to exchange RIP information, ensure that all devices on that network are configured to exchange RIP information. The FTOS default is to send RIPv1, and to receive RIPv1 and RIPv2. To change the RIP version globally, use the version command in the ROUTER RIP mode. When RIP is enabled, you can view the global RIP configuration by using the show running-config command in the EXEC mode or the show config command in the ROUTER RIP mode. FTOS(conf-router_rip)#show config ! router rip network 10.0.0.0 FTOS(conf-router_rip)# Routing Information Protocol | 823