Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 458

www.dell.com | support.dell.com show ip interface Command Example FTOS#show ip int gi 0/8 GigabitEthernet 0/8 is up, line protocol is up Internet address is 10.69.8.1/24 Broadcast address is 10.69.8.255 Address determined by config file MTU is 1554 bytes Inbound access list is not set Proxy ARP is enabled Split Horizon is enabled Poison Reverse is disabled ICMP redirects are not sent ICMP unreachables are not sent FTOS# Configure static routes A static route is an IP address that is manually configured and not learned by a routing protocol, such as OSPF. Often static routes are used as backup routes in case other dynamically learned routes are unreachable. To configure a static route, use the following command in the CONFIGURATION mode: Command Syntax Command Mode ip route ip-address mask {ip-address | interface [ip-address]} [distance] [permanent] [tag tag-value] CONFIGURATION Purpose Configure a static IP address. Use the following required and optional parameters: • ip-address: Enter an address in dotted decimal format (A.B.C.D). • mask: Enter a mask in slash prefix-length format (/X). • interface: Enter an interface type followed by slot/port information. • distance range: 1 to 255 (optional). • permanent: Keep the static route in the routing table (if interface option is used) even if the interface with the route is disabled. (optional) • tag tag-value range: 1 to 4294967295. (optional) You can enter as many static IP addresses as necessary. To view the configured routes, use the show ip route static command. FTOS#show ip route static Destination Gateway Dist/Metric Last Change ----------- ------- S 2.1.2.0/24 Direct, Nu 0 0/0 00:02:30 S 6.1.2.0/24 via 6.1.20.2, Te 5/0 1/0 00:02:30 S 6.1.2.2/32 via 6.1.20.2, Te 5/0 1/0 00:02:30 S 6.1.2.3/32 via 6.1.20.2, Te 5/0 1/0 00:02:30 S 6.1.2.4/32 via 6.1.20.2, Te 5/0 1/0 00:02:30 S 6.1.2.5/32 via 6.1.20.2, Te 5/0 1/0 00:02:30 458 | IPv4 Addressing