Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 98

www.dell.com | support.dell.com Task Command Syntax Display Link Layer OAM sessions. show ethernet oam summary FTOS# show ethernet oam summary Output format : Symbols:* - Master Loopback State, # - Slave Loopback State Capability codes:L - Link Monitor, R - Remote Loopback U - Unidirection,V - Variable Retrieval LocalRemote InterfaceMAC AddressOUIModeCapability Gi6/1/10023.84ac.b8000000DactiveL R Command Mode EXEC Privilege Adjust the OAMPDU Transmission Parameters Task Command Syntax Specify a the maximum or minimum number of OAMPDUs to be sent per second. Set the transmission mode to active or passive. Specify the amount of time that the system waits to receive an OAMPDU from a peer before considering it non-operational. ethernet oam [max-rate value | min-rate value] Range: 1-10 Default: 10 ethernet oam mode {active | passive} Default: Active ethernet oam timeout value Range: 2-30 seconds Default: 5 seconds Command Mode INTERFACE INTERFACE INTERFACE Link Performance Event Monitoring Link Performance Event Monitoring OAM monitors the receive side of a link for a set of pre-defined errors and executes an action when a threshold is exceeded; it is enabled by default. Both peers on the link must be have link performance event monitoring enabled for discovery to complete. There is a high and low threshold for each pre-defined error; an event occurs when any threshold is exceeded. FTOS periodically polls hardware registers for the current frame and symbol error count. If an interface exceeds a threshold, a notification is sent to the peer and the interface is placed in error-disabled state. • Enable Error Monitoring • Execute an Action upon Exceeding the High Threshold 98 | 802.3ah