Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 679

Command Example: show ip ospf process-id (fast-convergence enabled) FTOS(conf-router_ospf-1)#fast-converge 2 FTOS(conf-router_ospf-1)#ex FTOS(conf)#ex FTOS#show ip ospf 1 Routing Process ospf 1 with ID 192.168.67.2 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 2 Min LSA origination 0 secs, Min LSA arrival 0 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 FTOS# Command example: show ip ospf process-id (fast-convergence disabled) FTOS#(conf-router_ospf-1)#no fast-converge FTOS#(conf-router_ospf-1)#ex FTOS#(conf)#ex FTOS##show ip ospf 1 Routing Process ospf 1 with ID 192.168.67.2 Supports only single TOS (TOS0) routes SPF schedule delay 5 secs, Hold time between two SPFs 10 secs Convergence Level 0 Min LSA origination 5 secs, Min LSA arrival 1 secs Number of area in this router is 0, normal 0 stub 0 nssa 0 FTOS# Change OSPFv2 parameters on interfaces In FTOS, you can modify the OSPF settings on the interfaces. Some interface parameter values must be consistent across all interfaces to avoid routing errors. For example, you must set the same time interval for the hello packets on all routers in the OSPF network to prevent misconfiguration of OSPF neighbors. Use any or all of the following commands in CONFIGURATION INTERFACE mode to change OSPFv2 parameters on the interfaces: Command Syntax Command Mode Usage ip ospf cost CONFIG-INTERFACE Change the cost associated with OSPF traffic on the interface. Cost: 1 to 65535 (default depends on the interface speed). ip ospf dead-interval CONFIG-INTERFACE seconds Change the time interval the router waits before declaring a neighbor dead. Configure Seconds range: 1 to 65535 (default is 40 seconds). The dead interval must be four times the hello interval. The dead interval must be the same on all routers in the OSPF network. ip ospf hello-interval CONFIG-INTERFACE seconds Change the time interval between hello-packet transmission. Seconds range: from 1 to 65535 (default is 10 seconds). The hello interval must be the same on all routers in the OSPF network. Open Shortest Path First (OSPFv2 and OSPFv3) | 679