Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 686

www.dell.com | support.dell.com Note: If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a specific OSPF process. If you do not enter the Process ID, only the first configured process is listed. Use the show running-config ospf command to see the state of all the enabled OSPFv2 processes. Command Syntax Command Mode Usage show running-config ospf EXEC Privilege View the summary of all OSPF process IDs enables on the router. FTOS#show run ospf ! router ospf 3 ! router ospf 4 router-id 4.4.4.4 network 4.4.4.0/28 area 1 ! router ospf 5 ! router ospf 6 ! router ospf 7 mib-binding ! router ospf 8 ! router ospf 90 area 2 virtual-link 4.4.4.4 area 2 virtual-link 90.90.90.90 retransmit-interval 300 ! ipv6 router ospf 999 default-information originate always router-id 10.10.10.10 Use the following commands in EXEC Privilege mode to get general route and links status information. Command Syntax show ip route summary show ip ospf database Command Mode Usage EXEC Privilege EXEC Privilege View the summary information of the IP routes View the summary information for the OSPF database Use the following command in EXEC Privilege mode to view the OSPFv2 configuration for a neighboring router: Command Syntax show ip ospf neighbor Command Mode Usage EXEC Privilege View the configuration of OSPF neighbors. 686 | Open Shortest Path First (OSPFv2 and OSPFv3)