Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 68

www.dell.com | support.dell.com Display your FTP configuration using the command show running-config ftp from EXEC Privilege mode, as shown in the example in Enable FTP server. Configure FTP client parameters When the system will be an FTP client, configure FTP client parameters: Task Specify a source interface. Configure a password. Enter username to use on FTP client. Command Syntax Command Mode ip ftp source-interface interface CONFIGURATION ip ftp password password CONFIGURATION ip ftp username name CONFIGURATION Display the FTP configuration using the command show running-config ftp from EXEC Privilege mode, the example in Enable FTP server. Terminal Lines You can access the system remotely and restrict access to the system by creating user profiles. The terminal lines on the system provide different means of accessing the system. The console line (console) connects you through the Console port in the RPMs. The virtual terminal lines (VTY) connect you through Telnet to the system. The auxiliary line (aux) connects secondary devices such as modems. Deny and Permit Access to a Terminal Line Force 10 recommends applying only standard ACLs to deny and permit access to VTY lines. • Layer 3 ACL deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny any traffic. • You cannot use show ip accounting access-list to display the contents of an ACL that is applied only to a VTY line. To apply an IP ACL to a line: Task Apply an ACL to a VTY line. Command Syntax ip access-class access-list Command Mode LINE To view the configuration, enter the show config command in the LINE mode, as shown in the following example. FTOS(config-std-nacl)#show config ! ip access-list standard myvtyacl 68 | System Management