Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 440

www.dell.com | support.dell.com Assign a debounce time to an interface Command Syntax Command Mode link debounce time [milliseconds] INTERFACE Purpose Enter the time to delay link status change notification on this interface. Range: 100-5000 ms • Default for Copper is 3100 ms • Default for Fiber is 100 ms FTOS(conf)#int gi 3/1 FTOS(conf-if-gi-3/1)#link debounce time 150 FTOS(conf-if-gi-3/1)#= Show debounce times in an interface show interface debounce EXEC Privilege [type] [slot/port] Show the debounce time for the specified interface. Enter the interface type keyword followed by the type of interface and slot/port information: • For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. FTOS# FTOS#show interfaces debounce gigabitethernet 3/1 Interface Time(ms) GigabitEthernet 3/1 200 FTOS# Note: FTOS rounds the entered debounce time up to the nearest hundredth. Note in the example in Assign a debounce time to an interface that the timer was set at 150 ms, but appears as 200 in the example in Show debounce times in an interface. Disable ports when one only SFM is available (E300 only) Selected ports can be shut down when a single SFM is available on the E300 system. Each port to be shut down must be configured individually. When an E300 system boots up and a single SFM is active this configuration, any ports configured with this feature will be shut down. All other ports are booted up. Similarly, if an SFM fails (or is removed) in an E300 system with two SFM, ports configured with this feature will be shut down. All other ports are treated normally. When a second SFM is installed or replaced, all ports are booted up and treated as normally. This feature does not take affect until a single SFM is active in the E300 system. 440 | Interfaces