Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 432

www.dell.com | support.dell.com Note: For IPV6, only the first 32 bits (LSB) of IP Source Address and IP Destination Address are used for hash generation. The following example shows the configuration and show command for packet-based hashing on the E-Series. FTOS(conf)#load-balance ip-selection packet-based FTOS#show running-config | grep load load-balance ip-selection packet-based FTOS# The load-balance packet based command can co-exist with load balance mac command to achieve the functionality shown in Table 23-5, "The load-balance Commands and Port Channel Types," in Interfaces. IPv4, IPv6, and non-IP traffic handling on the E-Series The table below presents the combinations of the load-balance command and their effect on traffic types. Table 23-5. The load-balance Commands and Port Channel Types Configuration Commands Default (IP 5-tuple) load-balance ip-selection 3-tuple load-balance ip-selection mac load-balance ip-selection 3-tuple load-balance ip-selection mac load-balance ip-selection packet-based load-balance ip-selection packet-based load-balance ip-selection mac Switched IP Traffic IP 5-tuple (lower 32 bits) IP 3-tuple (lower 32 bits) MAC-based MAC-based Packet based: IPV4 No distribution: IPV6 MAC-based Routed IP Traffic (IPv4 only) IP 5-tuple IP 3-tuple IP 5-tuple IP 3-tuple Packet-based Packet-based Switched Non-IP Traffic MAC-based MAC-based MAC-based MAC-based MAC-based MAC-based C-Series and S-Series load-balancing For LAG hashing on C-Series and S-Series, the source IP, destination IP, source TCP/UDP port, and destination TCP/UDP port are used for hash computation by default. For packets without a Layer 3 header, FTOS automatically uses load-balance mac source-dest-mac. IP hashing or MAC hashing should not be configured at the same time. If you configure an IP and MAC hashing scheme at the same time, the MAC hashing scheme takes precedence over the IP hashing scheme. 432 | Interfaces