Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 759

Showing CAM PBR Configuration Example FTOS(conf-if-gi-8/1)#do show cam pbr l 8 p0 TCP Flag: Bit 5 - URG, Bit 4 - ACK, Bit 3 - PSH, Bit 2 - RST, Bit 1 - SYN, Bit 0 - FIN Cam Port VlanID Proto Tcp Src Dst SrcIp DstIp Next-hop Egress Index Flag Port Port MAC Port 06080 0 N/A IP 0x0 0 0 200.200.200.200 200.200.200.200 199.199.199.199 199.199.199.199 N/A N/A 06081 0 N/A TCP 0x10 0 40 234.234.234.234 255.234.234.234 222.222.222.222/24 00:00:00:00:00:09 8/1 Sample Configuration The following configuration is an example for setting up a PBR. These are not comprehensive directions. They are intended to give you a some guidance with typical configurations. You can copy and paste from these examples to your CLI. Be sure you make the necessary changes to support your own IP Addresses, Interfaces, Names, etc. Figure 40-2 is a graphic illustration of the configuration shown in the output examples below the figure. The Redirect-List GOLD defined in this example, creates the following rules: • description Route Gold traffic to the DS3. • seq 5 redirect 10.99.99.254 ip 192.168.1.0/24 any • " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.1.0/24." • seq 10 redirect 10.99.99.254 ip 192.168.2.0/24 any • " Redirect to next-hop router IP 10.99.99.254 any traffic originating in 192.168.2.0/24." • seq 15 permit ip any any Policy-based Routing | 759