Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 232

www.dell.com | support.dell.com Use these commands in the following sequence, starting in the CONFIGURATION mode to configure an IP extended community list. Step Command Syntax 1 ip extcommunity-list extcommunity-list-name 2 {permit | deny} {{rt | soo} {ASN:NN | IPADDR:N} | regex REGEX-LINE} Command Mode Purpose CONFIGURATION Create a extended community list and enter the EXTCOMMUNITY-LIST mode. CONFIG-COMMUNITY-LIST Two types of extended communities are supported. Filter routes based on the type of extended communities they carry using one of the following keywords: • rt: Route Target • soo: Route Origin or Site-of-Origin. Support for matching extended communities against regular expression is also supported. Match against a regular expression using the following keyword: • regexp: regular expression To set or modify an extended community attribute, use the set extcommunity {rt | soo} {ASN:NN | IPADDR:NN} command. To view the configuration, use the show config command in the CONFIGURATION COMMUNITY-LIST or CONFIGURATION EXTCOMMUNITY LIST mode or the show ip {community-lists | extcommunity-list} command in EXEC Privilege mode . FTOS#show ip community-lists ip community-list standard 1 deny 701:20 deny 702:20 deny 703:20 deny 704:20 deny 705:20 deny 14551:20 deny 701:112 deny 702:112 deny 703:112 deny 704:112 deny 705:112 deny 14551:112 deny 701:667 deny 702:667 deny 703:667 deny 704:666 deny 705:666 deny 14551:666 FTOS# 232 | Border Gateway Protocol IPv4 (BGPv4)