Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1038

www.dell.com | support.dell.com EXEC Privilege Command History Version 7.8.1.0 Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 Introduced support of Multi-Process OSPF. Introduced process-id option, in support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series and E-Series Usage If you are using Multi-Process OSPF, you must enter the Process ID to view information regarding a Information specific OSPF process. If you do not enter the Process ID, only the first configured process is listed. Use this command to isolate problems with external routes. In OSPF, external routes are calculated by adding the LSA cost to the cost of reaching the ASBR router. If an external route does not have the correct cost, use this command to determine if the path to the originating router is correct. The display output is not sorted in any order. Note: ASBRs that are not in directly connected areas are also displayed. Example Figure 38-7. Command Example: show ip ospf process-id asbr FTOS#show ip ospf 1asbr RouterID 3.3.3.3 1.1.1.1 Flags Cost Nexthop -/-/-/ 2 10.0.0.2 E/-/-/ 0 0.0.0.0 Interface Area Gi 0/1 1 - 0 FTOS# You can determine if an ASBR is in a directly connected area (or not) by the flags. For ASBRs in a directly connected area, E flags are set. In the figure above, router 1.1.1.1 is in a directly connected area since the Flag is E/-/-/. For remote ASBRs, the E flag is clear (-/-/-/) show ip ospf database c e s Display all LSA information. If OSPF is not enabled on the switch, no output is generated. Syntax show ip ospf process-id database [database-summary] Parameters process-id database-summary Enter the OSPF Process ID to show a specific process. If no Process ID is entered, command applies only to the first OSPF process. (OPTIONAL) Enter the keywords database-summary to the display summary of the information stored in the OSPFv2 database of the router, including the number of LSAs received from OSPFv2 neighbor routers. Command Modes EXEC EXEC Privilege Command History Version 7.8.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.1 Introduced support of Multi-Process OSPF. Introduced on S-Series Introduced on C-Series Introduced on E-Series 1038 | Open Shortest Path First (OSPFv2 and OSPFv3)