Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 362

www.dell.com | support.dell.com Usage Information FTOS software resolves the network address configured by the network command with the routes in the main routing table to ensure that the networks are reachable via non-BGP routes and non-default routes. Related Commands redistribute Redistribute routes into BGP. Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series network backdoor c e s Specify this IGP route as the preferred route. Syntax network ip-address mask backdoor To remove a network, use the no network ip-address mask backdoor command. Parameters ip-address mask Enter an IP address in dotted decimal format of the network. Enter the mask of the IP address in the slash prefix length format (for example, /24). The mask appears in command outputs in dotted decimal format (A.B.C.D). Defaults Not configured. Command Modes ROUTER BGP Usage Though FTOS does not generate a route due to backdoor config, there is an option for injecting/ Information sourcing a local route in presence of network backdoor config on a learned route. Command History Version 7.8.1.0 Version 7.7.1.0 Introduced support on S-Series Introduced support on C-Series redistribute c e s Redistribute routes into BGP. Syntax redistribute {connected | static} [route-map map-name] To disable redistribution, use the no redistribution {connected | static} command. Parameters connected Enter the keyword connected to redistribute routes from physically connected interfaces. 362 | Border Gateway Protocol IPv4 (BGPv4)