Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 770

www.dell.com | support.dell.com Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage If the number parameter is the same as the AS number used in the router bgp command, the remote Information AS entry in the neighbor is considered an internal BGP peer entry. This command creates a peer and the newly created peer is disabled (shutdown). Related Commands router bgp Enter the ROUTER BGP mode and configure routes in an AS. neighbor remove-private-as c e Remove private AS numbers from the AS-PATH of outgoing updates. Syntax Parameters neighbor {ipv6-address | peer-group-name} remove-private-as To return to the default, use the no neighbor {ipv6-address | peer-group-name} remove-private-as command. ipv6-address peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the name of the peer group to remove the private AS numbers Defaults Disabled (that is, private AS number are not removed). Command Modes Command History ROUTER BGPV6-ADDRESS FAMILY Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage Information Applies to EBGP neighbors only. If the AS-PATH contains both public and private AS number or contains AS numbers of an EBGP neighbor, the private AS numbers are not removed. If a confederation contains private AS numbers in its AS-PATH, the software removes the private AS numbers only if they follow the confederation numbers in the AS path. Private AS numbers are 64512 to 65535. neighbor route-map c e Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group. 770 | IPv6 Border Gateway Protocol (IPv6 BGP)