Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 162
virtual-ip, write, Command Example: virtual ip IPv4 and IPv6
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
www.dell.com | support.dell.com virtual-ip c e Syntax Parameters Configure a virtual IP address for the active management interface. Virtual addresses can be configured both for IPv4 and IPv6 independently. virtual-ip {ipv4-address | ipv6-address} {ipv4-address | ipv6-address} Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::) of the active management interface. Defaults No default behavior or values Command Modes CONFIGURATION Command History Version 8.4.1.0 Added support for IPv6 addressing. Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.5.1.0 Introduced on C-Series E-Series original Command Usage Information Both IPv4 and IPv6 virtual address can be configured simultaneously, but only one of each. Each time this command is issued it will replace the previously configured address of the same family, IPv4 or IPv6. The no virtual-ip command now takes an address/prefix-length argument, so that the desired address only is removed. If no virtual-ip is entered without any specified address, then both IPv4 and IPv6 virtual addresses are removed. Example Figure 5-65. Command Example: virtual ip (IPv4 and IPv6) FTOS#virtual-ip 10.11.197.99/16 FTOS#virtual-ip fdaa:bbbb:cccc:1004::60/64 write c e s Copy the current configuration to either the startup-configuration file or the terminal. Syntax write {memory | terminal} Parameters memory terminal Enter the keyword memory to copy the current running configuration to the startup configuration file. This command is similar to the copy running-config startup-config command. Enter the keyword terminal to copy the current running configuration to the terminal. This command is similar to the show running-config command. Command Modes EXEC Privilege Command History Version 8.1.1.0 Introduced on E-Series ExaScale Version 7.6.1.0 Introduced on S-Series Version 7.5.1.0 Introduced on C-Series E-Series original Command 162 | Control and Monitoring