Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 380

www.dell.com | support.dell.com Command Modes EXEC EXEC Privilege Command History Version 7.8.1.0 Version 7.7.1.0 Version 7.5.1.0 Version 7.2.1.0 Version 6.3.10 Introduced support on S-Series Introduced support on C-Series Added detail option and output now displays default MED value Added received and denied route options The output is changed to display the total number of advertised prefixes Example 1 Figure 12-16. Command Example: show ip bgp neighbors (Partial) #show ip bgp neighbors BGP neighbor is 100.10.10.2, remote AS 200, external link BGP version 4, remote router ID 192.168.2.101 BGP state ESTABLISHED, in this state for 00:16:12 Last read 00:00:12, last write 00:00:03 Hold time is 180, keepalive interval is 60 seconds Received 1404 messages, 0 in queue 3 opens, 1 notifications, 1394 updates 6 keepalives, 0 route refresh requests Sent 48 messages, 0 in queue 3 opens, 2 notifications, 0 updates 43 keepalives, 0 route refresh requests Minimum time between advertisement runs is 30 seconds Minimum time before advertisements start is 0 seconds Capabilities received from neighbor for IPv4 Unicast : MULTIPROTO_EXT(1) ROUTE_REFRESH(2) CISCO_ROUTE_REFRESH(128) Capabilities advertised to neighbor for IPv4 Unicast : MULTIPROTO_EXT(1) ROUTE_REFRESH(2) ROUTE_REFRESH(2) GRACEFUL_RESTART(64) CISCO_ROUTE_REFRESH(128) Route map for incoming advertisements is test Maximum prefix set to 4 with threshold 75 For address family: IPv4 Unicast BGP table version 34, neighbor version 34 5 accepted prefixes consume 20 bytes Prefix advertised 0, denied 4, withdrawn 0 Prefixes accepted 1 (consume 4 bytes), withdrawn 0 by peer Prefixes advertised 0, rejected 0, withdrawn 0 from peer Connections established 2; dropped 1 Last reset 00:18:21, due to Maximum prefix limit reached 380 | Border Gateway Protocol IPv4 (BGPv4)