Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1103
ip pim ingress-interface-map, ip pim neighbor-filter, ip pim join-filter Command Example
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1103 highlights
Example Figure 41-1. ip pim join-filter Command Example FTOS(conf)# ip access-list extended iptv-channels FTOS(config-ext-nacl)# permit ip 10.1.2.3/24 225.1.1.0/24 FTOS(config-ext-nacl)# permit ip any 232.1.1.0/24 FTOS(config-ext-nacl)# permit ip 100.1.1.0/16 any FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels in FTOS(config-if-gi-1/1)# ip pim join-filter iptv-channels out Related Commands ip access-list extended Configure an access list based on IP addresses or protocols. ip pim ingress-interface-map c e s When the Dell Force10 system is the RP, statically map potential incoming interfaces to (*,G) entries to create a lossless multicast forwarding environment. Syntax ip pim ingress-interface-map std-access-list Parameters std-access-list Enter the name of an standard access list that permits the Defaults None Command Modes INTERFACE Command History Example Version 8.4.1.0 Introduced FTOSFTOS(conf)# ip access-list standard map1 FTOS(config-std-nacl)# permit 224.0.0.1/24 FTOS(config-std-nacl)#exit FTOS(conf)#int gig 1/1 FTOS(config-if-gi-1/1)# ip pim ingress-interface-map map1 ip pim neighbor-filter c e s Configure this feature to prevent a router from participating in protocol independent Multicast (PIM). Syntax ip pim neighbor-filter {access-list} To remove the restriction, use the no ip pim neighbor-filter {access-list} command. Parameters access-list Enter the name of a standard access list. Maximum 16 characters. Defaults Defaults. Command Modes CONFIGURATION. Command History Version 8.1.1.0 Version 7.8.1.0 Version 7.6.1.0 Introduced on E-Series ExaScale Introduced on C-Series and S-Series Introduced on the E-Series PIM-Sparse Mode (PIM-SM) | 1103