Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 704

www.dell.com | support.dell.com destination address message-type count byte log monitor Enter the IPv6 address of the network or host to which the packets are sent in the x:x:x:x::x format followed by the prefix length in the /x format. Range: /0 to /128 The :: notation specifies successive hexadecimal fields of zero. (OPTIONAL) Enter an ICMP message type, either with the type (and code, if necessary) numbers or with the name of the message type. Range: 0 to 255 for ICMP type; 0 to 255 for ICMP code (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword log to enter ACL matches in the log. Supported on Jumbo-enabled line cards only. (OPTIONAL) Enter the keyword monitor to monitor traffic on the monitoring interface specified in the flow-based monitoring session along with the filter operation. Defaults Not configured. Command Modes ACCESS-LIST Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced on the E-Series TeraScale and S-Series Introduced on the E-Series ExaScale Introduced on the C-Series Added monitor option Related Commands deny permit Configure a filter to drop packets. Configure a filter to forward packets. 704 | IPv6 Access Control Lists (IPv6 ACLs)