Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 877
xfff, STATIC_BIT=0, HIT_SA, show mac-address-table Command Output Example
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 877 highlights
Command Modes Command History Example EXEC EXEC Privilege Version 7.6.1.0 Introduced on C-Series Figure 30-1. show cam maccheck linecard Command Output Example FTOS#show cam maccheck linecard 2 port-set 0 Dumping entries. From 0 to 16383. Progress . marks 100 memory table entries Index 5576 (0x15c8) has valid entries (H: 2b9, E: 0) ..........Index 6592 (0x19c0) has valid entries (H: 338, E: 0) output truncated Usage Information Use this command to check various flags associated with each MAC address in the CAM. Figure 30-1 shows information for two MAC addresses. The second entry is for MAC address 00:00:a0:00:00:00 (leading 0s are not shown), which is shown as learned on VLAN ID 4094 (0xfff), as shown below in Figure 30-2 and Figure 30-3. Above, "STATIC_BIT=0" means that the address is dynamically learned. When an entry is listed as STATIC_BIT=1, its HIT_SA is 0, which signifies that this address is not getting continuously learned trough traffic. The HIT_DA is set when a new learn happens, and after the first age sweep, it gets reset. Example Figure 30-2. show mac-address-table Command Output Example FTOS#show mac-address-table VlanId Mac Address 4094 00:00:a0:00:00:00 Type Interface Dynamic Gi 2/0 State Active output truncated Example Figure 30-3. show cam mac linecard Command Output Example FTOS#show cam mac linecard 2 port-set 0 VlanId Mac Address Region Interface 0 ff:ff:ff:ff:ff:ff STATIC 00001 4094 00:00:a0:00:00:00 DYNAMIC Gi 2/0 output truncated Layer 2 | 877