Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 667
load-balance mac, show ip flow
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 667 highlights
Related Commands clear ip fib linecard Clear FIB entries on a specified line card. show ip flow c e s Show how a Layer 3 packet is forwarded when it arrives at a particular interface. Syntax show ip flow interface [vrf vrf instance] interface {source-ip address destination-ip address} {protocol number [tcp | udp] | icmp} {src-port number destination-port number} Parameters vrf instance interface interface source-ip address destination-ip address protocol number [tcp | udp] | icmp src-port number destination-port number E-Series Only: Show only the L3 flow as they apply to that VRF process. Enter the keyword interface followed by of the following interface keywords. • For a Fast Ethernet interface, enter the keyword FastEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a SONET interface, enter the keyword sonet followed by the slot/ port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. (OPTIONAL) Enter an in or out parameter in conjunction with the optional interface: Enter the keyword source-ip followed by the IP source address in IP address format. Enter the keyword destination-ip followed by the IP destination address in IP address format. E-Series only: Enter the keyword protocol followed by one of the protocol type keywords: tcp, udp, icmp or protocol number Enter the keyword src-port followed by the source port number. Enter the keyword destination-port followed by the destination port number. Command Modes EXEC Command History Version 8.1.1.0 Version 7.9.1.0 Version 7.6.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Introduced VRF on the E-Series Introduced on S-Series Introduced on S-Series Introduced on C-Series Introduced for E-Series Usage Information This command provides egress port information for a given IP flow. This is useful in identifying which interface the packet will follow in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed packed only. For switched packets use the show port-channel-flow command show ip flow does not compute the egress port information when load-balance mac hashing is also configured due to insufficient information (the egress MAC is not available). IPv4 Routing | 667