Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1519
Trace Logging Commands
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1519 highlights
port interface stg vlan interface number The keywords port interface show Layer 2 information for a port on a particular line card. The keyword stg shows the state of each port in a particular Spanning Tree Group on a line card. The keyword vlan shows Layer 2 information in the MAC Agent for a VLAN on a particular line card. Enter one of the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. Enter a number after the following keywords: • After the keyword linecard: Range: 0-7 for the C300; 0-3 for the C150 • After the port-channel keyword, enter the port-channel number. • Range: 1-128 • After the keyword stg, enter the Spanning Tree Group number. • After the keyword vlan: Range: 1 - 4095 for the C300 Defaults None. Command Mode EXEC EXEC Privilege Command History Version 4.2.1.0 Introduction Usage Information Warning: Use this command only when you are working directly with a technical support representative to troubleshoot a problem. Do not use this command unless a technical support representative instructs you to do so. Trace Logging Commands Trace logging is a critical debugging tool most often used by the Dell Force10 Technical Assistance Center (TAC) to isolate and resolve both software and hardware issues. • debug cpu-traffic-stats • show command-history • show console lp • show cpu-traffic-stats • show hardware linecard fpga • show hardware rpm fpga C-Series Diagnostics and Debugging | 1519