Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1528

www.dell.com | support.dell.com Example Figure 64-18. show hardware linecard (C-Series Command Example) FTOS#show hardware linecard 7 poe-status HW Status for POE Controller 0 The HW Status is The Internal address is - 0x0000 The I2C address is - 0x003c Is Master - Yes The I2C Mode is - I2C The mode is configured properly The address is configured properly The Controller and I2C is configured properly FTOS# Usage Information Related Commands If the command is executed on a non-POE line card, the following error message is generated: FTOS#sh hardware linecard 6 poe-status % Error: POE is not supported for this card. show power supply Display the power supply status. Buffer Tuning Commands The buffer tuning commands are: • buffer (Buffer Profile) • buffer (Configuration) • buffer-profile (Configuration) • buffer-profile (Interface) • show buffer-profile • show buffer-profile interface Warning: Altering the buffer allocations is a sensitive operation. Do not use any buffer tuning commands without first contacting the Dell Force10 Technical Assistance Center. buffer (Buffer Profile) c s Allocate an amount of dedicated buffer space, dynamic buffer space, or packet pointers to queues 0 to 3. Syntax buffer [dedicated | dynamic | packet-pointers] queue0 number queue1 number queue2 number queue3 number Parameters dedicated dynamic packet-pointers Enter this keyword to configure the amount of dedicated buffer space per queue. Enter this keyword to configure the amount of dynamic buffer space per Field Processor. Enter this keyword to configure the number of packet pointers per queue. 1528 | C-Series Diagnostics and Debugging