Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 429

13 Content Addressable Memory (CAM) Overview Content Addressable Memory (CAM) commands are supported C-Series, E-Series TeraScale and S-Series, as indicated by the symbols under each command heading: c et s This chapter includes information relating to the E-Series TeraScale platform. Refer to Chapter 13, Content Addressable Memory (CAM) for ExaScale for information on the commands for the E-Series ExaScale platform. Note: Not all CAM commands are supported on all platforms. Be sure to note the platform symbol when looking for a command. Warning: If you are using these features for the first time, contact the Dell Force10 Technical Assistance Center (TAC) for guidance. For information on contacting Dell Force10 TAC, visit the Dell Force10 website at www.force10networks.com/support This chapter includes the following sections: • CAM Profile Commands • CAM IPv4flow Commands • CAM Layer 2 ACL Commands CAM Profile Commands The CAM profiling feature enables you to partition the CAM to best suit your application. For example: • Configure more Layer 2 FIB entries when the system is deployed as a switch. • Configure more Layer 3 FIB entries when the system is deployed as a router. • Configure more ACLs (when IPv6 is not employed). • Hash MPLS packets based on source and destination IP addresses for LAGs. • Hash based on bidirectional flow for LAGs. • Optimize the VLAN ACL Group feature, which permits group VLANs for IP egress ACLs. Content Addressable Memory (CAM) | 429