Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 671

Example Figure 24-18. show ip management route Command Example FTOS#show ip management-route Destination ----------10.1.2.0/24 172.16.1.0/24 Gateway ------ManagementEthernet 0/0 10.1.2.4 State ----Connected Active FTOS# show ipv6 management-route c e Display the IPv6 static routes configured for the management interface. Syntax show ipv6 management-route [all | connected | summary | static] Parameters all connected summary static Enter the keyword all to view all IP addresses assigned to all Management interfaces on the switch. Enter the keyword connected to view only routes directly connected to the Management interface. Enter the keyword summary to view a table listing the number of active and non-active routes and their sources. Enter the keyword static to view non-active routes also. Command Modes Command History Example EXEC Privilege Version 8.4.1.0 Introduced FTOS#show ipv6 management-route IPv6 Destination Gateway ------- 2001:34::0/64 ManagementEthernet 0/0 2001:68::0/64 2001:34::16 FTOS# State ----Connected Active show ip protocols c e s View information on all routing protocols enabled and active on the switch. Syntax show ip protocols Command Modes EXEC EXEC Privilege Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on E-Series ExaScale Regular evaluation optimization enabled/disabled added to display output Introduced on S-Series Introduced on C-Series Introduced for E-Series IPv4 Routing | 671