Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1454
upstream, upstream Command Example
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1454 highlights
www.dell.com | support.dell.com upstream s S50 only Assign a port or port-channel to the uplink-state group as an upstream interface. Syntax Parameters upstream interface interface Enter one of the following interface types: Fast Ethernet: fastethernet {slot/port | slot/port-range} 1-Gigabit Ethernet: gigabitethernet {slot/port | slot/port-range} 10-Gigabit Ethernet: tengigabitethernet {slot/port |slot/port-range} Port channel: port-channel {1-512 | port-channel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: gigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5 A comma is required to separate each port and port-range entry. Defaults None Command Modes UPLINK-STATE-GROUP Command History Usage Information Version 8.4.2.3 Introduced on the S-Series S50. You can assign physical port or port-channel interfaces to an uplink-state group. You can assign an interface to only one uplink-state group. Each interface assigned to an uplink-state group must be configured as either an upstream or downstream interface, but not both. You can assign individual member ports of a port channel to the group. An uplink-state group can contain either the member ports of a port channel or the port channel itself, but not both. To delete an uplink-state group, enter the no upstream interface command. Related Commands downstream uplink-state-group Assign a port or port-channel to the uplink-state group as a downstream interface. Create an uplink-state group and enabling the tracking of upstream links. Example Figure 60-5. upstream Command Example FTOS(conf-uplink-state-group-16)# upstream gigabitethernet 1/10-15 FTOS(conf-uplink-state-group-16)# 1454 | Uplink Failure Detection (UFD)