Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1402

www.dell.com | support.dell.com Command Modes CONFIGURATION Command History Version 8.3.1.0 Version 7.7.1.0 Added the all option Introduced on S-Series Usage Information Enabling this command keeps the failed switch in the failed state. It will not reboot until it is manually rebooted. When enabled, it is not displayed in the running-config. When disabled, it is displayed in the running-config. Related Commands show redundancy Display the current redundancy status. redundancy force-failover stack-unit s Force the backup unit in the stack to become the management unit. Syntax redundancy force-failover stack-unit Defaults Not enabled Command Modes EXEC Privilege reset stack-unit s Reset any designated stack member except the management unit (master unit). Syntax Parameters reset stack-unit 0-7 hard 0-7 hard Enter the stack member unit identifier of the stack member to reset. Reset the stack unit if the unit is in a problem state. Default none Command Modes Command History CONFIGURATION Version 8.3.1.0 Version 7.8.1.0 Version 7.7.1.0 Added hard reset option. Augmented to run on the standby unit in order to reset the standby unit directly. Introduced on S-Series Usage Resetting the management unit is not allowed, and an error message will be displayed if you try to do Information so. Resetting is a soft reboot, including flushing the forwarding tables. Starting with FTOS 7.8.1.0, you can run this command directly on the stack standby unit (standby master) to reset the standby. You cannot reset any other unit from the standby unit. 1402 | S-Series Stacking Commands