Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1245

offset interface Enter a number from zero (0) to 16 to be applied to the incoming route metric matching the access list specified. If you set an offset value to zero (0), no action is taken. (OPTIONAL) Enter the following keywords and slot/port or number information: • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a Port Channel interface, enter the keyword port-channel followed by a number: C-Series and S-Series Range: 1-128 E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale. • For a SONET interface, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN, enter the keyword vlan followed by a number from 1 to 4094. Defaults Not configured. Command Modes ROUTER RIP Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage When the offset metric is applied to an interface, that value takes precedence over an offset value that Information is not extended to an interface. Related Commands ip prefix-list Enter the PREFIX-LIST mode and configure a prefix list. output-delay c e s Set the interpacket delay of successive packets to the same neighbor. Syntax output-delay delay To return to the switch software defaults for interpacket delay, enter no output-delay. Parameters delay Specify a number of milliseconds as the delay interval. Range: 8 to 50. Default Not configured. Command Modes ROUTER RIP Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Router Information Protocol (RIP) | 1245