Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 647
ip helper-address hop-count disable, ip host
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 647 highlights
Version 7.5.1.0 pre-Version 6.2.1.1 Added support for C-Series Introduced on E-Series Usage Information You can add multiple DHCP servers by entering the ip helper-address command multiple times. If multiple servers are defined, an incoming request is sent simultaneously to all configured servers and the reply is forwarded to the DHCP client. FTOS uses standard DHCP ports, that is UDP ports 67 (server) and 68 (client) for DHCP relay services. It listens on port 67 and if it receives a broadcast, the software converts it to unicast, and forwards to it to the DHCP-server with source port=68 and destination port=67. The server replies with source port=67, destination port=67 and FTOS forwards to the client with source port=67, destination port=68. ip helper-address hop-count disable c e s Disable the hop-count increment for the DHCP relay agent. Syntax ip helper-address hop-count disable To reenable the hop-count increment, use the no ip helper-address hop-count disable command. Defaults Enabled; the hops field in the DHCP message header is incremented by default Command Modes CONFIGURATION Command History Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 Version 6.3.1.0 Introduced on E-Series ExaScale Added support for S-Series Added support for C-Series Introduced for E-Series Usage Information This command disables the incrementing of the hops field when boot requests are relayed to a DHCP server through FTOS. If the incoming boot request already has a non-zero hops field, the message will be relayed with the same value for hops. However, the message will be discarded if the hops field exceeds 16, to comply with the relay agent behavior specified in RFC 1542. Related Commands ip helper-address show running-config Specify the destination broadcast or host address for DHCP server requests. Display the current configuration and changes from default values. ip host c e s Assign a name and IP address to be used by the host-to-IP address mapping table. Syntax ip host name ip-address To remove an IP host, use the no ip host name [ip-address] command. IPv4 Routing | 647