Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1556
Offline Diagnostic Commands
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1556 highlights
www.dell.com | support.dell.com show environment (C-Series and E-Series) show processes memory (C-Series and E-Series) Display system component status. Display memory usage based on running processes. Offline Diagnostic Commands The offline diagnostics test suite is useful for isolating faults and debugging hardware. The tests results are written to a file in flash memory and can be displayed on screen. Detailed statistics for all tests are collected. These statistics include: • last execution time • first test pass time and last test pass time • first test failure time and last test failure time • total run count • total failure count • consecutive failure count • error code The offline diagnostics commands are: • diag linecard • offline • online • show diag diag linecard e Run offline diagnostics on a line card(s). Syntax diag linecard number {alllevels | level0 | level1 | level2} | {terminate} To terminate the offline diagnostics, use the diag linecard number terminate command. Parameters number alllevels level0 level1 level2 terminate Enter the line card slot number. Range: 0 to 13 on a E1200, 0 to 6 on a E600, and 0 to 5 on a E300. Enter the keyword alllevels to run the complete offline diagnostic test. Enter the keyword level0 to check the device inventory and verify the existence of the devices. Enter the keyword Level1 to verify that the devices are accessible via the designated paths (line integrity tests) and test the internal registers of the devices. Enter the keyword level2 to perform on-board loopback tests on various data paths (data Port-Pipe and Ethernet). Enter the keyword terminate to stop the offline diagnostics tests. 1556 | E-Series Debugging and Diagnostics