Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1446
clear ufd-disable, interface, uplink-state-group
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1446 highlights
www.dell.com | support.dell.com clear ufd-disable s S50 only Re-enable one or more downstream interfaces on the switch/router that are in a UFD-disabled error state so that an interface can send and receive traffic. Syntax clear ufd-disable {interface interface | uplink-state-group group-id} Parameters interface interface uplink-state-group group-id Specifies one or more downstream interfaces. For interface, enter one of the following interface types: Fast Ethernet: fastethernet {slot/port | slot/port-range} 1-Gigabit Ethernet: gigabitethernet {slot/port |slot/port-range} 10-Gigabit Ethernet: tengigabitethernet {slot/port |slot/port-range} Port channel: port-channel {1-512 | port-channel-range} Where port-range and port-channel-range specify a range of ports separated by a dash (-) and/or individual ports/port channels in any order; for example: gigabitethernet 1/1-2,5,9,11-12 port-channel 1-3,5 A comma is required to separate each port and port-range entry. Re-enables all UFD-disabled downstream interfaces in the group. Valid group-id values are 1 to 16. Defaults A downstream interface in an uplink-state group that has been disabled by UFD is disabled and in a UFD-disabled error state. Command Modes CONFIGURATION Command History Version 8.4.2.3 Introduced on the S-Series S50. Related Commands downstream uplink-state-group Assign a port or port-channel to the uplink-state group as a downstream interface. Create an uplink-state group and enabling the tracking of upstream links. 1446 | Uplink Failure Detection (UFD)