Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 767
neighbor next-hop-self, neighbor peer-group assigning peers
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 767 highlights
neighbor next-hop-self c e Allows you to configure the router as the next hop for a BGP neighbor. (This command is used for IBGP). Syntax neighbor {ipv6-address | peer-group-name} next-hop-self To return to the default setting, use the no neighbor {ipv6-address | peer-group-name} next-hop-self command. Parameters ipv6-address peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. (OPTIONAL) Enter the name of the peer group. Defaults Disabled. Command Modes ROUTER BGPV6-ADDRESS FAMILY Command History Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale Usage If the set ipv6 next-hop command in the ROUTE-MAP mode is configured, its configuration takes Information precedence over the neighbor next-hop-self command. neighbor peer-group (assigning peers) c e Allows you to assign one peer to a existing peer group. Syntax neighbor ipv6-address peer-group peer-group-name To delete a peer from a peer group, use the no neighbor ipv6-address peer-group peer-group-name command. Parameters ipv6-address peer-group peer-group-name Enter the IPv6 address in the x:x:x:x::x format. The :: notation specifies successive hexadecimal fields of zeros. Enter the keyword peer-group followed by the name of a configured peer group. (maximum 16 characters) Defaults Not configured. Command Modes Command History ROUTER BGP Version 8.4.2.1 Version 8.2.1.0 Version 7.4.1.0 Introduced on C-Series and S4810. Introduced on E-Series ExaScale Introduced on E-Series TeraScale IPv6 Border Gateway Protocol (IPv6 BGP) | 767