Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1242
ip rip send version, ip split-horizon
View all Dell Force10 S25N-S50N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1242 highlights
www.dell.com | support.dell.com Command Modes INTERFACE Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage If you want the interface to receive both versions of RIP, enter ip rip receive version 1 2. Information Related Commands ip rip send version version Sets the RIP version to be used for sending RIP traffic on an interface. Sets the RIP version to be used for the switch software. ip rip send version c e s Set the interface to send a specific version of RIP. The version you set on the interface overrides the version command in the ROUTER RIP mode. Syntax ip rip send version [1] [2] To return to the default value, enter no ip rip send version. Parameters 1 2 (OPTIONAL) Enter the number 1 for RIP version 1. The default is RIPv1. (OPTIONAL) Enter the number 2 for RIP version 2. Defaults RIPv1. Command Modes INTERFACE Command History Version 7.8.1.0 Version 7.6.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage To enable the interface to send both version of RIP packets, enter ip rip send version 1 2. Information Related Commands ip rip receive version version Sets the RIP version for the interface to receive traffic. Sets the RIP version to be used for the switch software. ip split-horizon c e s Enable split-horizon for RIP data on the interface. As described in RFC 2453, the split-horizon scheme prevents any routes learned over a specific interface to be sent back out that interface. Syntax ip split-horizon To disable split-horizon, enter no ip split-horizon. 1242 | Router Information Protocol (RIP)