Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1419

Parameters stp-id protocol all bpdu config events general root Enter zero (0). The switch supports one Spanning Tree group with a group ID of 0. Enter the keyword for the type of STP to debug, either mstp, pvst, or rstp. (OPTIONAL) Enter the keyword all to debug all spanning tree operations. (OPTIONAL) Enter the keyword bpdu to debug Bridge Protocol Data Units. (OPTIONAL) Enter the keyword config to debug configuration information. (OPTIONAL) Enter the keyword events to debug STP events. (OPTIONAL) Enter the keyword general to debug general STP operations. (OPTIONAL) Enter the keyword root to debug STP root transactions. Command Modes EXEC Privilege Command History Version 7.7.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on S-Series Introduced on C-Series Introduced on E-Series Usage When you enable debug spanning-tree bpdu for multiple interfaces, the software only sends Information information on BPDUs for the last interface specified. Related Commands protocol spanning-tree Enter SPANNING TREE mode on the switch. description c e s Enter a description of the Spanning Tree Syntax description {description} To remove the description from the Spanning Tree, use the no description {description} command. Parameters description Enter a description to identify the Spanning Tree (80 characters maximum). Defaults No default behavior or values Command Modes SPANNING TREE (The prompt is "config-stp".) Command History Related Commands pre-7.7.1.0 protocol spanning-tree Introduced Enter SPANNING TREE mode on the switch. disable c e s Disable Spanning Tree Protocol globally on the switch. Syntax disable To enable Spanning Tree Protocol, enter no disable. Spanning Tree Protocol (STP) | 1419