Dell Force10 S25N-S50N FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series - Page 1388

www.dell.com | support.dell.com Parameters c2 value j0 value Enter the keyword c2 followed by value to set the path signal byte. Range: 0x00 to 0xFF hexadecimal (0-255 decimal) Default: 0xCF in hexidecimal (207 in decimal) Enter the keyword j0 to set the section trace byte. Range: 0x00 to 0xFF hexadecimal (0-255 decimal) Default: 0xCC (204 in decimal) Defaults as above Command Modes INTERFACE Usage You enter the flag C2 and J0 values in decimal, but the FTOS displays the values in hexidecimal in the Information show controllers sonet command output. framing e Set the type of framing used on a POS/SDH interface. Syntax framing {sdh | sonet} To return to the default, enter no framing. Parameters sdh sonet Enter the keyword sdh to specify Synchronous Digital Hierarchy (SDH) framing. Default: Sonet Enter the keyword sonet to specify SONET framing. Default: Sonet Defaults sonet Command Modes INTERFACE Usage Framing should be changed only when the interfaces are shutdown. Information hardware monitor mac action-on-error port-shutdown e Shut down and bring back up the port (flap). Syntax hardware monitor mac action-on-error port-shutdown Defaults Not configured Command Modes CONFIGURATION Command History Version 7.7.1.0 Introduced command 1388 | SONET